 |
|
Window
Screening
|
|
|||
|
Roller Identification |
||||
| If this is your roller: | Then do the following: | |||
 |
Remove the two (2) mounting screws found at the bottom of the door. The screws will be on each side of the wheel. Pull the roller out of it's slot. |
|||
 |
With a slotted screwdriver, wedge between the spring end and the door tab and push off. Then push the spring inward and out between the door tabs. Install the new roller by looping the spring through the tabs and using the screwdriver as a wedge in the opening to snap the spring onto the tab. |
|||
|
|
Remove the roller mounting screw located on the bottom of the door next to the roller. Make note of the spring's placement and then swing the roller out. Since the adjustment screw stays on the roller, remember to guide the new roller's adjustment screw back into place as you mount the new rollers. | |||
|
|
Look into the roller door slot. You will see the mounting screw at the end of the leaf spring. With a Phillips screwdriver, remove the screw and pull out the roller. Since the adjustment screw is at the top of the roller, you usually do not need to worry about adjusting your door after replacing the roller. | |||
|
|
Loosen or remove the roller mounting screw that is located about 2" from the bottom on the edge of the door. The roller mounting screw is usually found right above the adjustment screw hole. Now pull out the roller from its door frame, using pliers if needed. | |||
|
|
Replacing a top-hung screen door's rollers may require you to loosen the top track rollers with a small wrench so you can lift your door up and out of the bottom guide. Swing the door approximately 45 degrees and tilt the door out. With a screwdriver, replace the rollers, mounting the new ones in the same locations. | |||
|
|
The roller's mounting screw is located about 2" from the bottom, at the edge of the door. Make note of how the mounting screw is situated between the roller's frame and the top of the coil spring. Remove the mounting screw. This function gives the roller the anti-jump feature. Pull out the roller through the bottom, using pliers if needed. Slide the new roller into the door channel and then push the mounting/adjusting screw in-between the roller housing and spring, through the slot in the door. After you re-mount the door, push the adjustment screw down and tighten it to raise the door. | |||
|
|
First look into the roller opening and make note of the spring's placement. Remove the roller mounting screw located on top of the door frame, above the roller. Pull out the roller from the bottom. | |||
|
|
||||
|
|
||||
|
Home Product Categories Product Availability |
||||
