Product Categories

Product Availability

Catalogs

How-to

FAQ's

Safety

Links

Window Screening
Requires Adobe Reader

 

 

 

Sliding Screen Door Rollers

Tired of using your screen door as part of your exercise routine?  If so, then it is time for you to replace your worn-out screen door rollers.

    By following these step by step instructions, we hope to guide you through the screen door roller selection and replacement process.  After you complete the reading for each step, you should be able to remove your screen door from it's track, remove the roller from the door and with your roller in hand, select and purchase the replacement roller from your local hardware store, then install the new roller and remount your door.

    Please remember that there are hundreds of door manufacturers, all making four or five door models each, so you need to be prepared for the possibility that you may encounter some small variations from our step-by-step instructions.  If you don't find your roller listed or your roller replacement experience was different than described below, please feel free to write us an e-mail and tell us about it so we can add it to  our guide.

Door Removal:
Most screen doors use spring-loaded rollers to keep the door from jumping off of the track.  First lift your door up and down in the track.  Check if there is enough room to remove your door without adjusting the rollers.  If you can remove the door, go to Step 2 (Figure 2).  If not, please continue to Step 1 (Figure 1).

Step 1.  By rotating the
screwdriver counter-clockwise
you can lower the door
(Figure 1A and 1B)

Step 3.  Now swing the bottom of the
door out until you can drop the door
down and out of the top track.  Place
your screen door on a worktable or
sawhorse.

                                           Page 1                     Page 2, 3, 4                           

Home  Product Categories  Product Availability
Catalogs  How-To  FAQ's